![]() Calibration spectra are unique for each detector and cannot be interchanged between sensors.Toledo Angola and Western Railway Records, 1898-1986 * The calibration spectra for these nuclides are extracted from the active Medusa Calibration File (MCF) that is present on the device. The sum of the 40K, 238U, 232Th and 137Cs lines. The standard spectrum for 137Cs multiplied with the concentration shown in the Spectrum block The standard spectrum for 232Th multiplied with the concentration shown in the Spectrum block The standard spectrum for 238U multiplied with the concentration shown in the Spectrum block The standard spectrum for 40K multiplied with the concentration shown in the Spectrum block This is the accumulated spectrum by summing the grey dots Spectrum collected by the spectrometer, stabilised to an energy scale To access the built-in website, navigate to the IP-address, port 3333. Additionally, if your network supports multicast DNS (mDNS), the detector can be accessed by using the detector hostname. Detectors in the network can also be found by using the Medusa detector finder tool which can be downloaded from the Medusa Software section under software downloads and updates. Most routers have the option to set a unique IP-address based on the connected device. If there is a router in the network that provides the detector with an IP-address, this address has to be determined by checking the router settings. when the detector is connected directly to a computer, the detector will initialize with its default IP-address. If no IP-address is provided by your router, e.g. The detector will check if it receives an IP-address from a router. The detector can be accessed either by directly connecting the detector to a computer or by connecting it to a network using a router. Accessing the mDOS interface through the built-in website 3.1.1. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |